SCTimer/PWM START addressOffset = 0x014

If UNIFY = 1 in the CONFIG register, only the _L bits are used.

If UNIFY = 0 in the CONFIG register, this register can be written to as two registers START_L and START_H. Both the L and H registers can be read or written individually or in a single 32-bit read or write operation.

The bits in this register select which events, if any, clear the STOP bit in the Control register. (Since no events can occur when HALT is 1, only software can clear the HALT bit by writing the Control register.)

Table 1. SCTimer/PWM registerName = START addressOffset = 0x014
Bit Symbol Description Reset value
5:0 STARTMSK_L If bit n is one, event n clears the STOP_L bit in the CTRL register (event 0 = bit 0, event 1 = bit 1, event 5 = bit 5). 0
15:6 - Reserved. -
21:16 STARTMSK_H If bit n is one, event n clears the STOP_H bit in the CTRL register (event 0 = bit 16, event 1 = bit 17, event 5 = bit 21). 0
31:22 - Reserved. -

-->